10% OFF ON MAY 29TH WITH DISCOUNT CODE "MEMORIAL"

MiSTer Aluminum Case Round 2

A few notes:

  1. Open case box over container - just like first round the parts bags are prone to opening during transit. I tried to convince the factory to use thicker bags this time but the bags remained unchanged.
  2. Buttons aren't as tall as last round - I'll work on revising them to be 1mm taller next round. I actually like the closer to flush look as the buttons have very shallow actuation.
  3. VGA port opening is a bit too high and requires the screw anchors to be fully seated - will revise on next case rear panel.

Aluminum case round 1 install instructions with changes for round 2:

Changes

Nylon washers no longer needed

Button spacers have taller "shoulders" so they're less prone to falling out

USB bracket required as micro USB opening for USB bridge was removed